As you can ‘layer up’ different Adjustment Layers, try applying an HSL Adjustment alongside a Black & White Adjustment to alter the colours on your photograph and create interesting effects.With Protect Alpha enabled, the brush should change only the color of the lines without affecting anything else. (See note below if this checkbox is not visible.) Select the topmost duplicate layer & paint over the lines. Tips and tricksĪs the Black & White Adjustment is non-destructive you can edit it in different ways, without affecting your original photograph. Set the brush color to whatever you want & tick the ' Protect Alpha ' checkbox in the context toolbar. This also works for other non-destructive Adjustments, such as HSL, as shown in this article. You can also use the Selection Tools to precisely select areas of the image, and then by selecting the Black & White Adjustment Layer, use the Flood Fill Tool or Paint Brush Tool (set to black), or the Erase Brush Tool to remove the adjustment from that area. Have some fun by experimenting with different opacities and different brushes, too. Or use the Paint Brush Tool with white selected, to paint the adjustment back in. Note you can also use the Paint Brush Tool with black selected instead of the Erase Brush Tool to create the same effect. You’ll notice that on the Layers Panel, the Black & White Adjustment layer appears white and areas you have erased appear black. By erasing from the Black & White Adjustment layer, we are removing the adjustment from that area of the image. When you create a new Adjustment Layer, it creates a separate, non-destructive layer over your original image, which applies that adjustment to the layers below. Please turn on JavaScript to view this video A walkthrough of using a Black & White Adjustment layer. This creates a simple masked area, allowing the original colour to show through. Select the Erase Brush Tool (E) and with the Black & White Adjustment layer selected, start erasing the area you want to revert back to its original colour.In this image, we want to change the colour to black and white but keep the shoes red, so we are going to use a simple masking technique. If the selection includes unwanted areas, check Subtract at top left and paint to remove them. Paint over the land (not the sky) to select it. Grab the Selection Brush from the toolbar and check ‘ Snap to edges ’ in the options at the top. It also allows you to adjust the Blend Mode on the adjustment layer and the Opacity, although this can also be altered in the Layers Panel. Start by open your landscape shot into Affinity Photo. Tweaking these allows for richer tones of grey and greater control over the appearance of your black and white image. You’ll see that this creates a new Black & White Adjustment Layer in the Layers Panel.Ī Black & White panel will appear, allowing you to adjust the different colour values in your image. Go to the Adjustment Panel and select Black & White or click the Adjustments icon in the Layers Panel and select Black & White. To begin, open your image in Affinity Photo.
0 Comments
Leave a Reply. |