If a template is currently loaded in Connect Designer, the size and portrait attribute of the first section of that template are used as defaults for the Sample Page.Īs a general rule, it makes little sense to modify the Sample Page size within the Print Wizard (as the template media size will already have been selected), but it does make sense when creating Print Output Presets for other templates. The logical page size can be set independently of any template open in the Designer, allowing for output presets to be created independently from the active template. If Booklet Binding were selected, some of the imposition settings will be determined by the options made within the Booklet Options Page and those imposition settings will thus be disabled on this page. When using Impositioning everything within the Segment is Impositioned, so all meta data below the Job Segment level is lost. It is important to note that if Impositioning is used then the only meta data that will be available to the job thereafter will be the meta data at Job Segment level. You can even select how many pages are to be represented, whilst page numbers appear on the pages in the diagram and change dynamically, like everything else. Whenever selections are changed, this display changes to reflect the selections made. The options on the Imposition Options page allow for the setting of imposition repetition, order, margins and markings.Īs imposition selections are very specific and can be quite confusing, we have provided a handy dynamic diagram that displays a representation of the current imposition selections in real time. Imposition refers to the printing of multiple pages on a single sheet. This page appears as part of the Advanced Print Wizard and the Output Creation Preset Wizard.
0 Comments
Leave a Reply. |